|
Acrylic Stucco is a one-part mixture of high-performance
acrylics specially blended with an aggregate compound to provide a stucco texture. It is used as a one-coat system to apply a stucco look over all substrates without the labor and cost of
additional steps and primer. It can be applied to metal, concrete, masonry and wood.
SURFACE PREPARATION
As a single coat system over metal, concrete, masonry and wood, and Multi-Ceramic as a heat barrier:
 Power wash surface (3,500 psi) with a Chlor-Rid to remove loose or flaking paint, rust and salts, and to clean the surface of dirt, oil, tar, grease and film.
Surface must be completely dry.
As a one-coat system (metal, concrete, masonry and wood) or for new construction (metal, concrete, masonry and wood):
Power wash surface (3,500 psi) with a citrus cleaner to remove dirt, oil, tar, grease and film.
Surface must be completely dry. Previously coated (metal, concrete, masonry and wood)
Power wash surface (3,500 psi) with Chlor-Rid to remove loose or flaking paint, rust, and salts, and to clean the surface of dirt, oil, tar, grease and film.
Surface must be completely dry before applying the coating.
If existing coating surface is glossed, it must be sanded and roughed before application, no gloss.
NOTE: If pack rust, scale or bright glossy surfaces exist, they must be removed by grit blast, power tool or needle gun. Once removed, begin with step 1 (power wash).
MIXING
Acrylic Stucco should be mixed by power drill with paddle for ten minutes.
Begin application.
NOTE: Once a container is opened and not fully used, snap the lid back in place and the product can be utilized at a future date (the lid must be firmly in place).
POT LIFE: Four hours at 70F. degrees if container is left open. |
APPLICATION
Acrylic Stucco can be applied by trowel or spray:
If application is by trowel, use a standard stucco trowel.
If application is by spray, use a Graco Texspray 1500 with a flexhead pole gun for a smoother texture surface while wet.
MINIMUM SPREAD RATES
All clean and sealed surfaces--apply @ 20 sq.ft./ gallon (80 mils wet/62 mils dry)
CURE TIME
Twelve hours to touch at 70F. degrees.
Overcoating window is 24 hours at 70F. degrees or longer.
Fully cures in 7 days.
TEMPERATURE
Apply between 50F. and 100F. degrees.
Store between 50F. and 100F. degrees.
CLEAN-UP OF EQUIPMENT
After completion, spray systems should be cleaned with soap and water.
After completion, brushes and rollers can be cleaned with soap and water, stored and reused.
|
LIMITATION OF LIABILITY:
The information contained in this data sheet is based upon tests that we believe to be accurate and is intended for guidance only.
All recommendations or suggestions relating to the use of the products, whether in technical documentation, or in response to a specific enquiry, or otherwise, are based on data which to the best of our knowledge is reliable. The products and information are designed for users having the requisite knowledge and industrial skills, and the end-user has the responsibility to determine the suitability of the product for its intended use.
WP has no control over either the quality of condition of the
substrate, or the many factors affecting the use and application of the product. Therefore, WP does not accept any liability arising from loss, injury, or damage resulting from such use or the contents of this data sheet (unless there are written agreements stating otherwise). The information contained in this data sheet is subject to modification as a result of practical experience and continuous product development. This data sheet replaces and annuls all previous issues and the user
has the responsibility to ensure that this sheet is current prior to using the product.
|
|
Dry time: to touch - 12 hours to recoat - overnight 
